paycheck

← Check another job

Sheet Metal Workers in Los Angeles-Long Beach-Anaheim, CA

Sheet Metal Workers

Fabricate, assemble, install, and repair sheet metal products and equipment, such as ducts, control boxes, drainpipes, and furnace casings. Work may involve any of the following: setting up and operating fabricating machines to cut, bend, and straighten sheet metal; shaping metal over anvils, blocks, or forms using hammer; operating soldering and welding equipment to join sheet metal parts; or inspecting, assembling, and smoothing seams and joints of burred surfaces. Includes sheet metal duct installers who install prefabricated sheet metal ducts used for heating, air conditioning, or other purposes.

$34.96median, an hour
$39.27mean (average), an hour
2,440people employed in this job here

The bar runs from the 10th to the 90th percentile; the darker part is the middle half of earners.

Compare your pay

Show annual wages

The spread

US median
$0.00$50.00$100.00

How pay for this job is spread here: higher means more people earn around that amount, and the darker middle is the middle half of earners. The dots are BLS's published 10th, 25th, median, 75th and 90th percentiles; the curve between them is our smooth estimate. Hover or tap a dot for its figure.

This job is less common here than nationally: 0.4 in every 1,000 jobs (location quotient 0.5).

Where this job pays most

Median an hour by state, from lower to higher pay as in the key below. Hover or tap a state for its figure. Living costs differ too, so a higher wage is not always more to spend.

Top metro and nonmetro areas

Across California

Link to this page: /wages?occ=472211&area=0031080&per=hour. Your pay is never part of a link.